Hit the realy bad erea where the ground is full of trash from the two earlier buildings that burnt.It is so bad the Etrac would run 4 to max. of 9 in auto.I used factory coins with fast on deep off and dificult on.4 of the wheats have rust stuck on them from all the nails .Over half the coins were not even able to be pinpointed in pinpoint mode because of so much iron next to them. Digital numbers were all over the place as well.
None of the targets were over 6" as would be expected under these conditions.Several were one way hits only, but in pinpoint I could tell there was big iron close by and so dug them. I had to pick out several old rusted nails in most of the holes with my probe.
Starting to learn a little more about iffy signals under the above conditions.Sometimes even when there is a iron crackle mixed with a good signal it will be a coin very close to iron,especialy on one way hits.
The erea had not been hit very much because most machines are completely worthless there.I am sure there are a lot of good older coins left that even the Etrac can not reach through such heavy trash.My F75 will go nuts in this part of the lawn and the ferrous meter will almost peg out even with the little coil.
Did I dig some trash? Yes a lot more than usual as I have been digging very little most of the time.
Now if I just had more time to hunt, Ray.
PS any info on the button would be appreciated,Thanks
None of the targets were over 6" as would be expected under these conditions.Several were one way hits only, but in pinpoint I could tell there was big iron close by and so dug them. I had to pick out several old rusted nails in most of the holes with my probe.
Starting to learn a little more about iffy signals under the above conditions.Sometimes even when there is a iron crackle mixed with a good signal it will be a coin very close to iron,especialy on one way hits.
The erea had not been hit very much because most machines are completely worthless there.I am sure there are a lot of good older coins left that even the Etrac can not reach through such heavy trash.My F75 will go nuts in this part of the lawn and the ferrous meter will almost peg out even with the little coil.
Did I dig some trash? Yes a lot more than usual as I have been digging very little most of the time.
Now if I just had more time to hunt, Ray.
PS any info on the button would be appreciated,Thanks
Hope you get a chance to go back with a small coil.Thx for all the pics.HH